ALGIX 3D OMNI filament, 1.75 mm, 0.375 kg (0.83 lbs), White

Sold via Amazon Guru rating: coming soon
Producer: #ALGIX 3D

Color: White

Algix 3D Printer Filament, OMNI, Heavenly White, 1.75mm, 375g

1.75mm; Substitute for ABS; High Quality; Tight Tolerances

Compostable; Environmentally sustainable; Non-toxic.

Vibrant color palette; Smooth texture of finished parts.

Print at temperature range of 195-215°C

Spool diameter 17.78cm; Spool width 2.86cm; Spool hub hole 5cm

Material Properties

Physical Properties OMNI™ Characteristic Effects Melting Point (°C) 160 Polymer melting temperature Diameter Tolerances (%) ± 3% Variation in filament size Ovality (mm) 0.04 Difference between two diameters measured across the filament’s profile Density (g/cm3) 1.29 Density of filament material Melt Flow Index (195°C) 11.5 Viscosity of filament in molten state Tensile Strength at Yield (MPa) 41.85 The force required to deform Tensile Elongation @ Yield (%) 3.88 The amount of stretching before deforming Tensile Modulus (MPa) 2100 The rigidity or resistance to stretching Toughness (J) 0.20 The amount of energy required to deform Failure Mode Brittle Type of failure experienced at deformation Heat Deformation Temp (°C) 60 Temperature at which a part will begin to deform after being post annealed Volatile Compounds Detected 6 Number of identified compounds released during 3D printing Volatiles with Toxicity Concerns ≤ 1  Number of identified compounds with a toxic health hazard rating according to GHS exceeding the exposure threshold *Dependent on manufacturer Presence fluctuates and not present in food grade certified resin (available by special order)

Printing Properties

3D Printing Tips • Always print in an area with good airflow and minimal temperature fluctuations. • Be sure your build plate is level, clean and oil-free before printing. OMNI™ filament adheres well to glass or plastic and does not require a heated build plate like ABS filament. • If your machine does have a heated build plate, we do advise using it for larger prints set at a temperature of 50°C, and if your machine has a fan, we recommend using it for most prints. • It is recommended to use high water content hairspray (as opposed to high ethyl alcohol content) lightly sprayed on the surface and allowed to dry before starting prints to ensure the first layer of the print sticks to the plate. • This filament will run best at an extrusion temperature of 195-215°C (2.85mm filament usually prints at the higher end of this range). • If prints appear stringy lower temp in 5°C increments until your prints appear satisfactory. • For more stability and a higher quality print, consider experimenting with infills, print speeds, and layer heights. • For prints with curvatures, it is recommended to turn on rafts and supports in your settings.

Leave a comment